Tecnam P2002 JF - Page 86

2
nd
Edition - Rev 0
Page 8
05-20
INSPECTION PROGRAM
ATA
Item
Maintenance task
FREQUENCY
A
B
C
D
E
27
Flight controls
Inspect stabilator trim: check for full
travel and correct operation. Check
related indicator for operation.
X
28
Fuel System
Check fuel pump electrical connec-
tions. Check fuel line connections for
leakage. Control fireproof socks.
X
28
Fuel System
Clean electrical fuel pump filter.
X
28
Fuel System
Clean Gascolator filter. Check quick
drain valve for condition and opera-
tion.
X
28
Fuel System
Check and Rinse the fuel tanks
X
28
Fuel System
Clean Finger Screen Filters, replace if
needed.
X
28
Fuel System
Inspect fuel tanks and lines for leaks
and condition.
X
28
Fuel System
Inspect fuel tank vents free from ob-
struction.
X
28
Fuel System
Inspect fuel selector valve for leaks,
general condition and security of in-
stallation. Check fuel tank sump drain
valves for conditions and operation.
X
28
Fuel System
Inspect operation of fuel selector
valve control knob. Check for re-
stricted movement, interference or
unusual play.
X
30
Ice Protection
Control Heated Pitot annunciator
panel light operation. (If installed)
X
30
Ice Protection
Check Pitot heating system for opera-
tion. (if installed)
X
31
Indicating system
Inspect the individual instruments and
switch panels for general condition
and security of installation.
X
31
Indicating system
Check stall detector for integrity and
operation.
X