Tecnam P2002 JF - Page 88

2
nd
Edition - Rev 0
Page 10
05-20
INSPECTION PROGRAM
ATA
Item
Maintenance task
FREQUENCY
A
B
C
D
E
32
Landing gear
Check for play in wheel bearings.
Examine wheels: look especially for
cracks. Visually inspect the brakes
and examine linings for excessive
wear (if required replace linings) and
disks for distortion and excessive
wear.
X
32
Landing gear
Inspect the brakes lines and check re-
taining clamps.
X
32
Landing gear
Check for correct torque of the MLG
attachment bolts. Replace leather
spacer if necessary.
X
32
Landing gear
Check parking valve for damage,
leakage and security of installation.
Inspect parking brake handle, check
for restricted movement, interference
or unusual play.
X
32
Landing gear
Inspect rudder pedals for operation
and condition.
X
32
Landing gear
Check toe brakes for operation and
master cylinders/hoses for leaks.
X
32
Landing gear
Disassemble and inspect the brake as-
semblies and examine the parts (lin-
ing, disc and plates) for wear, cracks,
warpage, corrosion, elongated holes,
etc. Replace brake lining if required.
X
32
Landing gear
Check oil level in brake reservoir.
Replenish if needed.
X
32
Landing gear
Replace brake system hydraulic fluid:
at 800 hr or every 3 years (WOF)
X
33
Lights
Inspect strobe, landing and navigation
lights for operation, for condition and
security of installation. Check electri-
cal wiring.
X