Tecnam P2002 JF - Page 983

2
nd
Edition - Rev 0
SUPPLEMENT S1
Chapter 61 – Propeller
Page 203
Step
no.
Propeller installation
Task description
Additional info
&References
NOTE
NO MINIMUM SPACE HAS TO BE BETWEEN THEM
12.
Apply safety wires.
Reference Errore. L'o-
rigine riferimento non è
stata trovata.
13.
Check track of the blades on the trailing
edge about 10 cm inboard from the blade tip.
Refer to Hoffmann in-
stallation manual for the
max. permissible track
14.
Install spinner on support plates, observe
mating marks..
15.
Perform a functional check:
a) Adjust power lever for approx. 1800 rpm.
Pull propeller lever back(out) until the
rpm drops by 300. Push propeller lever
full forward (in) and observe rpm in-
crease. The time required for pitch change
should be about the same in both direc-
tion (rpm increase and decrease).
Cycle three times at least this procedure.
See engine starting and
shut-down procedure on
AFM. Keep parking
brake engaged.
See Hoffmann Propeller
CMM Chapter "Trouble-
shooting" to check, if the
propeller or governor
limits the rpm.
16.
After the ground runs, check for oil leaks
and blade shake