TEEJET 5000 OPERATORS MANUAL FERTILISER DISTRIBUTOR, OTHER TYPE
4.5
Stop driving and stop the spreader. When you are
ready to start spreading, press “DRIVE START” and
start spreading until 10% of the hopper size has been
spread.
NOTE: If you start spreading without pressing
“DRIVE START” a warning will be
displayed. You must now stop spreading
and wait 8 seconds, press “DRIVE START”
again.
After stopping the following will be displayed:
CALC. KG/HA:
Pressing this key calculates the application rate since
the last calculation. It is possible to continue
weighing/spreading once this key has been pressed.
DRIVE END:
Press this key when you have stopped spreading or
when the spreader is to be filled. The application rate
since the last calculation is calculated when this key is
pressed. The amount is also registered in the KG+
counter.
If the task function is being used, then the consumed
amount will be stored in the task that was opened
before spreading commenced.
PAUSE:
Pressing the “PAUSE” key allows a pause in
spreading and stops the “beeps” from the computer. It
is possible to start spreading again at anytime.
To Next Page
Loading...