During the system startup or fan-tray replacement, the inventory data of the fan-tray assembly and the
power module is displayed in the Inventory tab of CTC after a delay of approximately 6 minutes.
Note
To install the fan-tray assembly, it is not necessary to move any of the fiber-routing facilities.Note
Procedure
Step 1
Insert the fan-tray assembly in Slot B of the NCS 2002 chassis (see the figure below).
Figure 79: Installing the Fan-Tray Assembly
Cisco NCS 2000 Series Hardware Installation Guide
133
Installing the Cisco NCS 2002 Door and Other Modules
NTP-L35 Installing the Fan-Tray Assembly in the NCS 2002 Shelf
To Next Page
Loading...
