Cisco NCS 2006 - Page 276

•
NTP-L5 Opening and Removing the Standard
Door of the NCS 2006 Shelf , on page 252
•
NTP-L2 Mounting the Brackets in ANSI
Configuration , on page 163
•
Connect the chassis to the office ground. For
detailed instructions on how to ground the
chassis, see the Electrostatic Discharge and
Grounding Guide for Cisco NCS 2000 Series .
•
NTP-L8 Install the NCS 2006 ECU and ECU-S
Modules, on page 277
•
NTP-L9 Installing the Power Modules in the
NCS 2006 Shelf , on page 282
•
NTP-L10 Installing the LCD Module in the
NCS 2006 Shelf, on page 292
•
NTP-L12 Installing Power and Ground to the
NCS 2006 Shelf , on page 200
•
NTP-L11 Installing the Fan-Tray Assembly in
the NCS 2006 Shelf, on page 296
•
NTP-L13 Installing the Cable and Fiber
Modules, on page 222
•
NTP-L14 Attaching Wires to Alarm, Timing,
LAN, and Craft Pin Connections, on page 229
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Cisco NCS 2000 Series Hardware Installation Guide
248
Installing the Cisco NCS 2006 Door and Other Modules
NTP-L4 Installing the Standard Door of the NCS 2006 Shelf