Cisco NCS 2006 - Page 8

DLP-L22 Turning On and Verifying DC Office Power on the NCS 2006 Shelf 218
CHAPTER 16 Connecting and Routing the Cables 221
Cable Routing and Management 221
Default Module 221
Fiber Module 221
Cable and Fiber Routing 222
NTP-L13 Installing the Cable and Fiber Modules 222
DLP-L23 Removing the Fiber Module 223
DLP-L24 Installing the Cable Module 224
DLP-L25 Routing and Locking Cables 225
NTP-L14 Attaching Wires to Alarm, Timing, LAN, and Craft Pin Connections 229
DLP-L26 Installing Alarm Wires in NCS 2006 230
DLP-L27 Installing Timing Wires on NCS 2006 - ANSI 235
DLP-L28 Installing Timing Wires in NCS 2006 - ETSI 237
DLP-L29 Installing LAN Wires in NCS 2006 240
CHAPTER 17 NCS 2006 Shelf Installation Acceptance Test 243
NTP-L18 Performing NCS 2006 Shelf Installation Acceptance Test 243
CHAPTER 18 Installing the Cisco NCS 2006 Door and Other Modules 245
Front Door 245
NTP-L4 Installing the Standard Door of the NCS 2006 Shelf 247
NTP-L5 Opening and Removing the Standard Door of the NCS 2006 Shelf 252
DLP-L12 Opening the Standard Door of the NCS 2006 Shelf 253
DLP-L13 Removing the Standard Door of the NCS 2006 Shelf 255
NTP-L39 Install the Deep-Front Panel of the NCS 2006 257
NTP-L40 Remove the Deep-Front Panel of the NCS 2006 Shelf 265
External Connection Units 270
NCS 2006 ECU 270
NCS 2006 ECU-S 271
NCS 2006 ECU60-S 273
Alarm Connectors 275
Passive Unit Inventory Interfaces 275
VoIP or UDC 276
Cisco NCS 2000 Series Hardware Installation Guide
viii
Contents