Extreme Networks EAS 100-24t Switch CLI User Manual

Chapter 4: Management
Extreme Networks EAS 100-24t Switch CLI Manual
52
An active LLDP port on the switch always includes the mandatory data in its outbound
advertisements. And there are four optional data that can be configured for an
individual port or group of ports to exclude one or more of these data types from
outbound LLDP advertisements. The mandatory data type includes four basic types of
information (end of LLDPDU TLV, chassis ID TLV, port ID TLV, Time to Live TLV). The
mandatory type can not be disabled.There are also four data types which can be
optionally selected. They are port_description, system_name, system_description, and
system_capability.
This TLV optional data type determines whether the IEEE 802.1 organizationally
defined port VLAN TLV transmission is allowed on a given LLDP transmission capable
port.
This TLV optional data type indicates whether the corresponding Local System's
Protocol Identity instance will be transmitted on the port. The Protocol Identity TLV
provides a way for stations to advertise protocols that are important to the operation of
the network. Such as Spanning Tree Protocol, the Link Aggregation Control Protocol,
and numerous vendor proprietary variations which are responsible for maintaining the
topology and connectivity of the network. If EAPOL, GVRP, STP (including MSTP), and
LACP protocol identity is enabled on this port and it is enabled to be advertised, then
this protocol identity will be advertised.
This TLV optional data type indicates whether the corresponding Local System’s VLAN
name instance will be transmitted on the port. If a port is associated with multiple
VLANs those enabled VLAN IDs will be advertised.
This TLV optional data type indicates whether the corresponding Local System's
Protocol Identity instance will be transmitted on the port. The Protocol Identity TLV
provides a way for stations to advertise protocols that are important to the operation of
the network. Such as Spanning Tree Protocol, the Link Aggregation Control Protocol,
and numerous vendor proprietary variations which are responsible for maintaining the
topology and connectivity of the network. If EAPOL, GVRP, STP (including MSTP), and
LACP protocol identity is enabled on this port and it is enabled to be advertised, then
this protocol identity will be advertised.
Each Specific TLV in this extension can be enabled individually.
Parameters <portlist> - Specify a range of ports to be configured.
all - To set all ports in the system, use the “all” parameter.
notification - Enables or disables the SNMP trap notification of LLDP data changes
detected on advertisements received from neighbor devices. The default notification
state is disabled.
enable - Specifies that the notification option will be enabled.
disable - Specifies that the notification option will be disabled.
admin_status - Specifies the administration status.
tx_only - Configure the specified port(s) to transmit LLDP packets, but block inbound
LLDP packets from neighbor devices.
rx_only - Configure the specified port(s) to receive LLDP packets from neighbors, but
block outbound packets to neighbors.
tx_and_rx - Configure the specified port(s) to both transmit and receive LLDP packets.
disable - Disable LLDP packet transmit and receive on the specified port(s). The
default per port state is tx_and_rx.
mgt_addr - Specifies the management address.
ipv4 <ipaddr> - Specifies the IPv4 address.
enable - Specifies that the management address option will be enabled.
disable - Specifies that the management address option will be disabled.
basic_tlvs - Specifies the basic TLVS used.
config lldp ports

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English