HEIDENHAIN MANUALPLUS 620 - Page 1126

1126 HEIDENHAIN Technical Manual MANUALplus 620
CfgLaAxis
Axis-specific jerk and tolerance parameters in the axis parameter set
axTransJerk 401701 MP1222
to
MP1250
Maximum axis jerk at
segment transitions
833
axPathJerk 401703 MP1085
MP1097
MP1098
Axis-specific maximum
jerk in traverse direction
(software option 2)
835
axPathJerkHi 401704 MP1086
MP1097
MP1098
Axis-specific maximum
jerk in traverse direction at
rapid traverse (software
option 2)
835
axFilterErrWeight 401702 – Factor for filter error 837
CfgFilter
(up to NCK software version 597 110-05)
Global (system-wide) machining parameters for configuring the nominal position value filters:
 defaultPosition subfolder for global filter settings of the linear axes
 defaultCutterLoc subfolder for global filter settings of the tilting axes (M128)
shape 100405
100406
MP1200 Shape of the global
nominal position value filter
817
frequency 100405
100406
MP1210
MP1211
MP1212
MP1213
Limit frequency of the filter 817
hscMode 100405
100406
– Mode (only relevant with
HSC filter)
818
defaultManualOrder 100407 – Global order of the mean-
value filter for the Manual
Operation mode
818
Config
object
Machine parameters NCK
number
iTNC MP
number
Brief description Page