HEIDENHAIN MANUALPLUS 620 - Page 1127

January 2012 6.20 Commissioning 1127
CfgPositionFilter
(up to NCK software version 597 110-05)
Axis-specific machining parameters for configuring the nominal position value filters. Overwrite the
global settings under System / CfgFilter.
 "axisPosition" subfolder for axis-specific filter settings on linear axes.
 "axisCutterLoc" subfolder for axis-specific filter settings on tilting axes (M128).
shape 401606
401608
MP1200 Shape of the nominal
position value filter
817
frequency 401606
401608
MP1210
MP1211
MP1212
MP1213
Limit frequency of the filter 817
hscMode 401606
401608
– Mode (only relevant with
HSC filter)
818
manualFilterOrder 401605 – Axis-specific order of the
mean-value filter for the
Manual Operation mode.
Overwrites the setting in
MP_defaultManualOrder
for the respective axis.
818
typeFilter1
typeFilter2
100401
100403
MP1200 Type of the nominal
position value filter
822
822
orderFilter1
orderFilter2
100402
100404
– Order (= run length) of
second nominal position
value filter
822
822
CfgPositionFilter
(up to NCK software version 597 110-04)
Axis-specific machine parameters for configuring the nominal position value filters
filter1Shape 401601 MP1200 Shape of the first nominal
position value filter from
CfgFilter
823
filter1LimitFreq 401602 MP1212
MP1213
Limit frequency of the first
filter
823
filter2Shape 401603 MP1200 Shape of the second
nominal position value filter
from CfgFilter
823
filter2LimitFreq 401604 MP1212
MP1213
Limit frequency of the
second filter
823
manualFilterOrder 401605 – Axis-specific order of the
mean-value filter for the
Manual Operation mode.
818
Config
object
Machine parameters NCK
number
iTNC MP
number
Brief description Page