January 2012 4.10 List of Machine Parameters 441
CfgPlcMStrobe
Settings for M functions;
Output of M strobe from NC to PLC: Specifies the treatment of the M function during NC program
run and the mapping to the PLC markers.
[Key names with the name or numerical code of the M strobe]
e.g. M00, M917, G26, G720, etc.
min
103901
Number of the first M Function
First M function code described in the parameter
object. The properties described in this parameter
object apply for the specified M functions.
Format: Numerical value
Input: 0 to 9999
Default: 0
RESET
LEVEL3
1550
max
103902
(optional parameter)
Number of the largest M function
Code of the last (greatest) M function described in
the parameter object.
No input: The properties of the parameter object
apply only to the M function defined in MP_min.
Format: Numerical value
Input: 0 to 9999
Default: 0
RESET
LEVEL3
1550
signal
103903
(optional parameter)
Symbolic name or number of the PLC marker
that is set when the function is decoded.
If you have not entered a value in the parameter
MP_acknowledge, resetting this marker means
an acknowledgment of the strobe.
No input:
The data connected with the output of the strobe
are saved without synchronization with the PLC
program and the output is immediately
acknowledged.
Format: String
Input: PLC operand, max. 80 characters
RESET
LEVEL3
1551
acknowledge
103904
(optional parameter)
Symbolic name or number of the PLC marker
that is set for acknowledging the strobe
No input:
The strobe is reset with the PLC marker entered
in MP_signal.
Format: String
Input: PLC operand, max. 80 characters
RESET
LEVEL3
1551
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page
To Next Page
Loading...
