HEIDENHAIN MANUALPLUS 620 - Page 453

January 2012 4.10 List of Machine Parameters 453
externalTool
104110
(optional parameter)
Symbolic name or number of the PLC marker
that is set during decoding if a tool is loaded
that is not in the magazine
The definition of the marker is not necessary if the
magazine and pocket numbers are evaluated
elsewhere or are irrelevant.
Format: String
Input: PLC operand, max. 80 characters
RESET
LEVEL3
597 110-03
1579
internalTool
104111
Symbolic name or number of the PLC marker
that is set during decoding if a tool is loaded
that is in the magazine
The definition of the marker is not necessary if the
magazine and pocket numbers are evaluated
elsewhere or are irrelevant.
Format: String
Input: PLC operand, max. 80 characters
RESET
LEVEL3
1579
specialTool
104112
(optional parameter)
Symbolic name or number of the PLC marker
that is set during decoding if a special tool is
loaded
The definition of this marker is not necessary if no
special tools are used.
Format: String
Input: PLC operand, max. 80 characters
RESET
LEVEL3
597 110-03
1579
revoke
104113
(optional parameter)
Numbers of functions whose effect will be
canceled by the output of the strobe.
In the list, enter the numbers of the functions
whose effect will be canceled when this code is
output.
The parameter is effective for implementing the
state of the function in the status display and
during block scan.
Format: List [0 to 10]
Input: 0 to 9999
RESET
LEVEL3
1580
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page