January 2012 4.10 List of Machine Parameters 485
Simulation
Settings for the simulation
CfgSimGeneral
General settings
restartAtM99
114801
Restart with M99
Specifies whether an NC program ending with
M99 is to be simulated repeatedly.
Format: Selection menu
Input:
on:
If M99, then the NC program is simulated again.
off:
If M99, then the NC program is not simulated
again.
Default: off
PLC/Pgm
run is
locked
LEVEL1
1422
pathDelay
114802
Path delay
Influences the simulation speed. After the output
of a distance traversed, the control waits for the
time defined in that parameter.
Format: Numerical value
Input: 0.000 to 60 [s]
Default: 0
PLC/Pgm
run is
locked
LEVEL1
1422
CfgTimeDetGeneral
Calculating the operating times
toolChangeTime
115001
Time allowance for tool change
Defines the time for a tool change that is taken
into account during the simulation.
Format: Numerical value
Input: 0.000 to 10 000 000 [s]
Default: 0
PLC/Pgm
run is
locked
LEVEL1
1423
gearShiftingTime
115002
Time allowance for gear shifting
Defines the time for gear shifting that is taken into
account during the simulation.
Format: Numerical value
Input: 0.000 to 10 000 000 [s]
Default: 0
PLC/Pgm
run is
locked
LEVEL1
1423
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page
To Next Page
Loading...
