HEIDENHAIN MANUALPLUS 620 - Page 488

488 HEIDENHAIN Technical Manual MANUALplus 620
CfgSimBlank
Specification of the standard workpiece blank
outsideDiameter
115301
Outside diameter
Specifies the outside diameter of the worpiece
blank.
Format: Numerical value
Input: 0.000 to 100 000 [mm]
Default: 100
PLC/Pgm
run is
locked
LEVEL1
1426
blankLength
115302
Workpiece blank length
Specifies the total length of the workpiece blank.
Format: Numerical value
Input: 0.000 to 100 000 [mm]
Default: 80
PLC/Pgm
run is
locked
LEVEL1
1426
rightBlankEdge
115303
Oversize of the workpiece blank
Specifies the oversize of the workpiece blank
referenced to the workpiece datum.
Format: Numerical value
Input: –100 000.000 to 100 000 [mm]
Default: 0
PLC/Pgm
run is
locked
LEVEL1
1426
insideDiameter
115304
Inside diameter of the blank
Specifies the inside diameter of the worpiece
blank.
Format: Numerical value
Input: For hollow cylinders: Inside
diameter
in 0.000 to 100 000 [mm]
For solid worpieces:
enter 0 [mm]
Default: 0
PLC/Pgm
run is
locked
LEVEL1
1426
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page