HEIDENHAIN MANUALPLUS 620 - Page 503

January 2012 4.10 List of Machine Parameters 503
pathTolerance
201506
MP1202.0
Path tolerance for contour transitions after the
filter
The feed rate for corners and curvatures is limited
so that the filter error does not exceed this value.
The path tolerance can be changed with Cycle 32.
Format: Numerical value
Input: 0.0001 to 10.000 [mm]
Default: 0.010 [mm]
Allowed in
strobe
LEVEL3
828
pathToleranceHi
201507
MP1202.1
Path tolerance after the filter at rapid traverse
This value also applies to feed rates greater than
MP_maxG1Feed.
Format: Numerical value
Input: 0.0001 to 10.000 [mm]
Default: 0.010 [mm]
Allowed in
strobe
LEVEL3
828
maxPathYank
201508
Maximum yank on the path (dj/dt)
Format: Numerical value
Input: 0.0 to 1 000 000.0 [mm/sec4]
Default: 4 000.0 [mm/sec4]
Allowed in
strobe
LEVEL3
830
reduceCornerFeed
201516
MP1205
(optional parameter)
Reduction of the contouring feed rate at the
beginning of a contour element
Format: Selection menu
Input:
 TRUE:
Reduction of contouring feed rate active
(slower but more accurate if required)
 FALSE:
Reduction of contouring feed rate not active
(fast, but can be a little less accurate)
Allowed in
strobe
LEVEL3
836
CfgPlcStrobes
Definition of the M, S and T strobes for this channel
mStrobes
201601
List of M strobe descriptions in this channel
Format: List [0 to 300]
Input: Key name of the M function
Selection from CfgPlcMStrobe
RESET
LEVEL3
1548
sStrobe
201602
List of S strobe descriptions in this channel
Format: List [0 to 6]
Input: Key name of the S function
Selection from CfgPlcSStrobe
RESET
LEVEL3
1560
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page