HEIDENHAIN MANUALPLUS 620 - Page 530

530 HEIDENHAIN Technical Manual MANUALplus 620
CfgAxisHandwheel
Configuration of the handwheel for this axis
input
400201
Connection of the encoder handwheel
Format: Selection menu
Input: none or
X01 to X06
X35 to X38
X201 to X210
Default: none
PLC/Pgm
run is
locked
LEVEL3
1340
hsciCcIndex
400210
Index of the CC controller unit on the HSCI
chain
If more than one CC controller unit is used on the
HSCI chain, enter the CC index for the position
encoder input to which the handwheel is
connected. Only the CCs are counted, further
HSCI devices (e.g. PLs) are not relevant.
If only one CC is used, enter the value 0.
Format: Numerical value
Input: 0 to 4
Default: 0
PLC/Pgm
run is
locked
LEVEL3
1340
countDir
400202
Axis-dependent counting direction of the
handwheel
The parameter applies both for the handwheel at
the position input and for the serial handwheel
connected to X23.
Format: Selection menu
Input:
 positive:
Counting direction is positive
 negative:
Counting direction is negative
Default: positive
PLC/Pgm
run is
locked
LEVEL3
1335
distPerRevol
400203
Axis traverse per handwheel revolution
Applies to all connected handwheels (handwheel
at position input and at X23).
The value is multiplied by MP_speedFactor
(CfgHandwheel).
Format: Numerical value
Input: Distance in [mm]
Default: 1.0 [mm]
PLC/Pgm
run is
locked
LEVEL3
1344
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page