HEIDENHAIN MANUALPLUS 620 - Page 556

556 HEIDENHAIN Technical Manual MANUALplus 620
vCtrlSwithOnDelay
400928
MP2309.x
(optional parameter)
The time after switch-on after which the
controller parameters are adapted for a locked
brake.
The time in seconds [s] after switch-on in which
the controller parameters are adapted for a locked
brake. For the defined time, the parameters of the
control loop are reduced after the motor switch-on
in order to prevent oscillations.
Format: Numerical value
Input: 0.000 000 000 to 5 [s]
Default: 0
Allowed in
strobe
LEVEL 3
597 110-05
984
vCtrlTimeSwitchOff
400928
MP2173.x
(optional parameter)
Pulse switch-off of the power modules
Monitoring time for the braking process. If after
the time has expired the axes are still in motion,
the pulses of the power modules are switched
off.
The time must be greater than the maximum
electrical braking time for the axis/spindle.
Format: Numerical value
Input: 0.100 000 000 to 100 [s]
Default: 3 [s]
Allowed in
strobe
LEVEL 3
597 110-05
991
vCtrlSpinSpeedTol
400930
MP3540
(optional parameter)
Permissible spindle speed shortfall
Permissible lower limit of the actual spindle speed
multiplied by a percentage of the nominal speed.
If the current spindle speed falls below the
defined value, the MANUALplus 620 outputs an
error message.
Format: Numerical value
Input: 0 to 100 [%]
0: Monitoring inactive
Default: 0
Allowed in
strobe
LEVEL 3
597 110-05
1026
vCtrlSpinMinSpeed
400931
MP3542
(optional parameter)
Minimum spindle speed as of which the
monitoring in MP_vCrtrlSpinSpeedTol
becomes active
Format: Numerical value
Input: 0 to 16 666.666 666 667 [rpm]
0: Monitoring inactive
Default: 0
Allowed in
strobe
LEVEL 3
597 110-05
1026
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page