Reset menus
2.1 Country/language reset
Erases country and language settings. Printer will shut down and restart.
2.2 Soft reset
Erases all the custom user settings to their default values.
2.3 Hard reset
Erases all the settings and device self-calibrations including OOBE. Clears wireless settings and web services.
2.4 Web Server password
Erases the password set in the Web Server.
2.5 OOBE reset
Resets everything to factory default except Ink tubes and mandatory rmware upgrade.
2.9 Line feed mfg calibration
Deletes user media advance calibrations. Restores the manufacturing ones. Unit will power down and reboot.
System conguration
3.2 Set boot mode to user mode
Sets the unit from manufacturing mode to “user mode”. This option should only be used if Front Panel shows
a white grid (manufacturing mode).
Print diagnostics menu
4.1 Nozzle test
Description
Prints the nozzle health pattern. While performing this test, paper is needed in the Multi-sheet tray. Also, it is
required to be an A4 or Letter Size paper, or else there will be a paper size mismatch message. There will be
an option to print anyway.
4.2 Bypass Pen alignment
Description
Skips printhead alignment during start up or printhead replacement. This can be useful for some
troubleshooting.
4.3 Carriage servo
Description
ENWW Support menu 187
To Next Page
Loading...
