Operations not permitted
Service actions implying removal of covers:
Solution: Remove the printer from the rugged case;
1. Remove rugged case right side (2 T25 + 2 T30 screws).
2. Remove rugged case left side (2 T25 + 2 T30 screws).
3. Unscrew the 4 knobs that attach the unit to the stand (the rugged case is sandwiched between the stand
and printer).
4. Remove the unit from the stand and rugged case base.
5. Remove the covers.
PHA replacement:
Solution: Remove the rugged case right side component (2 T25 + 2 T30 screws).
Extra accessory pictures
ENWW Rugged Case Accessory 563
To Next Page
Loading...
