Scanbar FFC F9A30-67018
Removal
Tools: Screwdrivers; Torx 10, 15, 20, and 25
1. Remove the Rear Cover, see Rear Cover (MFP only) on page 464.
2. Remove the Left Cover, see Left Cover MFP SV Kit F9A30-67012 on page 268.
3. Remove the Bottom Platen, see Bottom Platen F9A30-67042 on page 431.
4. Remove the Scanbar, see Scanbars F9A30-67017 (HP DesignJet T830 MFP only) on page 425.
5. Pass the three FFC Cables through the holes.
6. Detach the three FFC Straps.
466 Chapter 5 Removal and installation ENWW
To Next Page
Loading...
