EasyManua.ls Logo

HP DesignJet T730

HP DesignJet T730
620 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Multi-sheet tray sensor bracket - Cable Cover loose
Question: When I open the roll cover, it hits the black Multi-sheet tray cover and falls out of place.
Answer: The black cover can be replaced back. There are no screws, it just snaps in. Customer can perform.
However the issue can happen repeatedly. If the CE visit is needed, CE should compress the metal bracket so it
retains the black cover better:
There will be a new design in the long term.
Noise issues while printing
Question: Customer claims there is noise while printing.
Answer: There are dierent sources for this generic “noise.” Listed here are common sources:
1. The Starwheel hanger is misassembled and the Carriage rubs against it.
600 Chapter 8 Appendices ENWW

Table of Contents

Other manuals for HP DesignJet T730

Related product manuals