Scanbars F9A30-67017 (HP DesignJet T830 MFP only)
Removal
1. Switch o the printer.
2. Unplug the power cable.
3. Open the Scanner.
4. Note the location of the three Scanbars.
IMPORTANT: If the scanbars are removed for any other reason than scanbar replacement, take note of
the scanbar serial number and the position in the scanner (Service Station side, Middle, Front Panel side
etc.). This is important so that the Pristine PRNU (White balance) calibration is not mixed if the scanbar
order is changed.
ENWW Scanbars F9A30-67017 (HP DesignJet T830 MFP only) 425
To Next Page
Loading...
