MEASurement Commands 2
Keysight N8262A Programming Guide 131
<expected_value> returns the expected value sent by the last CONFigure
command or +20 dBm by default. Note that when the display is showing dual
windows this value is meaningless.
The <resolution> returned is the same as the value returned by
DISPlay:WINDow:RESolution?. The format of the return is <NR1> in the range 1
through 4.
Example
Reset Condition
On reset:
The command function is set to :POWer:AC.
The expected power level is set to +20 dBm.
The source list on the N8262A is set to Channel A for the upper measurement on
both windows and Channel B for the lower measurement on both windows.
(SENSe2/SENSe1) OFF :POW:AC:RAT (@2),(@1)
(SENSe1/SENSe2) ON :POW:AC:RAT:REL (@1),(@2)
(SENSe2/SENSe1) ON :POW:AC:RAT:REL (@2),(@1)
(SENSe1/SENSe1) OFF POW:AC:RAT (@1),(@1)
(SENSe2/SENSe2) OFF POW:AC:RAT (@2),(@2)
(SENSe1/SENSe1) ON POW:AC:RAT:REL (@1),(@1)
(SENSe2/SENSe2) ON POW:AC:RAT:REL (@2),(@2)
CALCulate:MATH
CALCulate:RELative:
STATe
Function <source list>
CONF2? This command queries the current
configuration of the lower window/upper
measurement.
To Next Page
Loading...
