Keysight Technologies P Series - Read[1]|2|3|4[:Scalar][:Power:ac]:Ratio? [<Expected_Value>[,<Resolu Tion>[,<Source List>]]]

MEASurement Commands 2
Keysight N8262A Programming Guide 167
READ[1]|2|3|4[:SCALar][:POWer:AC]:RATio?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window’s measurement function to ratio mode
with relative mode off, aborts then initiates both Channel A and B, calculates the
ratio measurement result and places the result on the bus. The result is a ratio
based measurement and is expressed in the units defined by
UNIT[1]|2|3|4:POWer:RATio.
Syntax
Parameters
Refer to “Optional Parameters” on page 126 for additional details on the
parameters in this command.
NOTE
INITiate:CON Tinuous must be set to OFF on both channels, otherwise error
–213, “INIT ignored” occurs. If TRIGger:SOURce is set to BUS on either channel,
error –214, “Trigger deadlock” occurs.
:POW
:AC
?
:SCAL
:RAT
Space
expected_value
DEF
resolution
,
DEF
source list
,
READ
1
2
3
4