1 Power Meter Remote Operation
120 Keysight N8262A Programming Guide
Making Measurements on Wireless Communication Standards
The following sections describe typical measurements you may want to make.
They are also described, for soft front panel operation, in the User’s Guide.
The optimum method of measuring these Wireless Communication Standards is
to use the SYSTem:PRESet <character_data> command and use one of the
following values.
– GSM900 -See “GSM900” on page 480 for greater detail.
– EDGE -See “EDGE” on page 483 for greater detail.
– CDMAone -See “CDMAone” on page 487 for greater detail.
– CDMA2000 -See “CDMA2000” on page 491 for greater detail.
– WCDMA -See “W-CDMA” on page 495 for greater detail.
– BLUetooth -See “BLUetooth” on page 499 for greater detail.
– MCPa -See “MCPA” on page 502 for greater detail.
– RADar -See “RADAR” on page 505 for greater detail.
– WL802DOT11A -See “802.11a and HiperLan2” on page 508 for greater detail.
– WL802DOT11B -See “892.11b/g” on page 511 for greater detail.
– XEVDO -See “1xeV-DO” on page 514 for greater detail.
– XEVDV -See “1xeV-DV” on page 518 for greater detail.
– TDSCdma -See “TD-SCDMA” on page 521 for greater detail.
– NADC -See “NADC” on page 524 for greater detail.
– IDEN -See “iDEN” on page 528 for greater detail.
– DVB -See “DVB” on page 532 for greater detail.
– HIPERLAN2 -See “802.11a and HiperLan2” on page 508 for greater detail.
To Next Page
Loading...
Need help?
General
