TRIGger Subsystem 14
Keysight N8262A Programming Guide 569
INITiate Commands
Initiate commands allow you to place the power meter in the wait for trigger state.
The INITiate commands are overlapped, that is, the power meter can continue
parsing and executing subsequent commands while initiated. Note that the
pending operation flag is set, when the power meter enters an idle state and the
flag is cleared when it re-enters the idle state.
The following commands are described in this section:
INITiate[1]|2:CONTinuous <boolean>
INITiate[1]|2[:IMMediate]
INITiate:CONTinuous:ALL <boolean>
INITiate:CONTinuous:SEQuence[1]|2 <boolean>
INITiate[:IMMediate]:ALL
INITiate[:IMMediate]:SEQuence[1]|2
To Next Page
Loading...
