Keysight Technologies P Series

13 TRACe Subsystem
556 Keysight N8262A Programming Guide
TRACe[1]|2:MEASurement:TRANsition[1]|...|10:POSitive:DURation?
This command returns the n
th
positive transition duration found on a trace.
Syntax
Reset Condition
On reset, this parameter is not affected.
Example
Error Messages
– If a P-Series sensor is not connected, error –241, “Hardware missing” occurs.
– If a P-Series sensor is connected and Free Run trigger acquisition is selected,
error –221, “Settings conflict” occurs.
TRAC
:MEAS
1
2
:TRAN
:POS
:DUR
?
1
2|...|10
TRAC:MEAS:TRAN10:POS:DUR? This command returns the 10th positive
transition duration found on trace 1.
NOTE
If you attempt to measure a pulse out of the range of the capture, for example,
measure the 5th pulse and there are only 4 pulses displayed, the power meter
returns #0#0#0 as the result.