Keysight Technologies P Series

10 SENSe Subsystem
410 Keysight N8262A Programming Guide
SENSe[1]|2:TRACe:LIMit:LOWer <numeric_value>
This command sets the lower scale limit of the trace for the specified channel.
The units used are dependent on the current setting of SENS:TRAC:UNIT as shown
in Table 10-1.
Syntax
Table 10-1 Measurement units
Units:
SENS:TRAC:UNIT
Units:
SENS:TRAC:LIM:LOW
dBm dBm
WW
NOTE
The trace lower scale limit is maintained at a lower power than the upper scale
limit which is adjusted to be slightly greater than the lower scale limit if
necessary. Refer to “SENSe[1]|2:TRACe:LIMit:UPPer <numeric_value>” on
page 412 for further information on setting the trace upper scale limit.
:SENS
1
2
:TRAC
Space
?
numeric_value
DEF
MIN
MAX
MIN
MAX
Space
:LOW
:LIM