Keysight Technologies P Series - Output:recorder[1]|2:Feed <Data_Handle

OUTPut Subsystem 8
Keysight N8262A Programming Guide 317
OUTPut:RECorder[1]|2:FEED <data_handle>
This command specifies which measurement is sent to the recorder output
specified by the numeric value following RECorder, RECorder1 and RECorder2.
Syntax
Parameters
Example
Reset Condition
On reset, data_handle is set to its previous value.
OUTP :FEED
:REC
Space
?
1
2
data_handle
Item Description/Default Range of Values
data_handle The CALC block specifying the measurement to be sent to
the recorder output.
“CALC1” or “CALC”
“CALC2”
“CALC3”
“CALC4”
OUTP:REC2:FEED “CALC1” This command sends the CALC1
measurement to recorder output 2.