Keysight Technologies P Series

SERVice Subsystem 16
Keysight N8262A Programming Guide 633
SERVice:SENSor[1]|2:FREQuency:MAXimum?
This query returns the maximum frequency that can be measured by the currently
connected sensor. It is applicable to E-Series sensors only. Maximum frequency
information is stored in the sensor’s EEPROM.
Syntax
Example
Error Messages
– If no sensor is connected, error –241, “Hardware missing” occurs.
– If a a sensor other than an E-Series power sensor is connected, error –241
“Hardware missing” occurs.
– If the sensor, currently connected, does not contain the necessary information
in EEPROM, error –241 “Hardware missing” occurs.
SERV:SENS2:FREQ:MAX? This query returns the maximum frequency
that can be measured by the E-Series sensor
currently connected to Channel B.
SERV
1
2
:FREQ
?
:SENS
:MAX