14 TRIGger Subsystem
576 Keysight N8262A Programming Guide
Reset Condition
On reset (*RST), this command is disabled.
On preset (SYSTem:PRESet) and instrument power-up, this command is enabled.
Query
INITiate[1]|2:CONTinuous:SEQuence?
The query enters a 1 or 0 into the output buffer.
– 1 is returned when there is continuous triggering
– 0 is returned when there is only a single trigger
Query Example
INIT2:CONT:SEQ? This command queries whether Channel B is
set for single or continuous triggering.
To Next Page
Loading...
