Keysight Technologies P Series

12 SYSTem Subsystem
450 Keysight N8262A Programming Guide
SYSTem:COMMunicate:LAN:CURRent:DGATeway?
This command returns the current setting of the LAN IP router/gateway address in
use by the power meter.
Syntax
Example
NOTE
If DHCP or AutoIP are enabled and successful, then one of these IP address
modes assigns the LAN IP router/gateway address, otherwise it is the static LAN
IP router/gateway address
SYST
:COMM
:CURR
:DGAT
?
:LAN
SYST:COMM:LAN:CURR:DGAT? This command queries the current setting of
the LAN IP router/gateway address.