Keysight Technologies P Series

16 SERVice Subsystem
632 Keysight N8262A Programming Guide
SERVice:SENSor[1]|2:CPLace?
This query returns the calibration place in E-Series sensors. Calibration place
information is stored in the sensor’s EEPROM.
Syntax
Example
Error Messages
– If no power sensor is connected, error –241 “Hardware missing” occurs.
– If a sensor other than a P-Series or E-Series power sensor is connected, error
–241 “Hardware missing” occurs.
SERV:SENS2:CPL? This query returns the place of calibration of
the E-Series sensor connected to Channel B.
:CPL
?
SERV
1
2
:SENS