TRIGger Subsystem 14
Keysight N8262A Programming Guide 599
TRIGger[:SEQuence[1]|2]:DELay:AUTO <boolean>
This command is used to determine whether or not there is a settling-time delay
before a measurement is made.
When this command is set to:
– ON, the power meter inserts a settling-time delay before taking the requested
measurement and for subsequent measurements. This settling time allows the
internal digital filter to be updated with new values to produce valid, accurate
measurement results. The trigger with delay command allows settling time for
the internal amplifiers and filters. It does not allow time for power sensor
delay.
In cases of large power changes, the delay may not be sufficient for complete
settling. Accurate readings can be assured by taking two successive
measurements for comparison.
– OFF, no settling-time delay is inserted and the power meter makes the
measurement immediately a trigger is received.
– ONCE, a settling-time delay is inserted before taking the requested
measurement, for one measurement only.
TRIGger[:SEQuence[1]|2]:DELay:AUTO is ignored if
TRIGger[1]|2[:IMMediate] is used to trigger the power meter.
Syntax
:DEL
0|OFF
1|ON
Space
?
:AUTO
ONCE
TRIG
:SEQ
1
2
To Next Page
Loading...
Need help?
General
