Keysight Technologies P Series - Memory:clear Commands

MEMory Subsystem 7
Keysight N8262A Programming Guide 291
MEMory:CLEar Commands
These commands are used to remove the contents stored in the sensor calibration
tables (8480 Series sensors only), frequency dependent offset tables and save/
recall registers. This subsystem removes the data contents but does not affect the
name of the associated table or save/recall register.
The following commands are detailed in this section:
MEMory:CLEar:[NAME] <character_data>
MEMory:CLEar:TABLe
NOTE
The contents cleared using these commands are non-recoverable.