SENSe Subsystem 10
Keysight N8262A Programming Guide 399
Reset Condition
On reset, gate 1 is set to 100 µs and other gates to 0 s.
Query
SENSe[1]]|SENSe2:SWEep[1]|2|3|4:TIME?
The query returns the current length of the time-gated period.
Query Example
Error Messages
– If the command is used when a sensor other than a P-Series power sensor is
connected, error –241, “Hardware missing” occurs
SENS2:SWE2:TIME? This command queries the length of the
time-gated period for Channel B and gate 2.
To Next Page
Loading...
