Keysight Technologies P Series - Parameters

CALCulate Subsystem 3
Keysight N8262A Programming Guide 213
Parameters
Example
Reset Condition
On reset, the upper window measurements are set to Channel A ("(SENS1)") and
the lower window measurements to Channel B ("(SENS2)").
Item Description/Default Range of Values
string A single string value detailing the measurement type:
– The default is SENS1 if the upper window is selected, or
SENS2 if the lower window is selected.
“(SENS1)”
[a]
“(SENS2)”
[a]
“(SENS1–SENS1)”
[a]
“(SENS2–SENS2)”
[a]
“(SENS1/SENS1)”
[a]
“(SENS2/SENS2)”
[a]
“(SENS1–SENS2)”
[a]
“(SENS2–SENS1)”
[a]
“(SENS1/SENS2)”
[a]
“(SENS2/SENS1)”
[a]
[a] Quotes are mandatory. Either single or double quotes may be used.
CALC2:MATH “(SENS2/SENS1)” This command sets the lower window/upper
measurement to make a Channel B/A ratio
measurement.