Keysight Technologies P Series

STATus Subsystem 11
Keysight N8262A Programming Guide 421
STATus:DEVice (page 420)
STATus:OPERation (page 430)
STATus:OPERation:CALibrating[:SUMMary] (page 431)
STATus:OPERation:LLFail[:SUMMary] (page 432)
STATus:OPERation:MEASuring[:SUMMary] (page 433)
STATus:OPERation:SENSe[:SUMMary] (page 434)
STATus:OPERation:TRIGger[:SUMMary] (page 435)
STATus:OPERation:ULFail[:SUMMary] (page 436)
STATus:QUEStionable (page 437)
STATus:QUEStionable (page 439)
STATus:QUEStionable:CALibration[:SUMMary] (page 440)
STATus:QUEStionable:POWer[:SUMMary] (page 441)
Examples
–To use the :CONDition? command to examine the STATus:DEVice register:
STATus:DEVice:CONDition?
–To use the :NTRansition command to examine the
STATus:OPERation:SENSe[:SUMMary] register:
STATus:OPERation:SENSe[:SUMMary]:NTRansition
This chapter describes the status register set commands and the status registers
which they are used to examine.