Keysight Technologies P Series

13 TRACe Subsystem
538 Keysight N8262A Programming Guide
TRACe Subsystem
The TRACe subsystem is used to:
– Specify the type of trace to be captured.
– Enable/disable trace capture.
– Specify the trace units.
There are two pre-defined TRACE blocks:
– TRACe1: associated with Channel A
– TRACe2: associated with Channel B
The following commands are described in this chapter:
Keyword Parameter Form Notes Page
TRACe[1]|2
[:DATA]? <character_data> [query only] page 540
:DEFine
:DURation
:REFerence <numeric_value> page 542
:TRANsition
:REFerence <numeric_value>,
<numeric_value>
page 544
:MEASurement
:INSTant
:REFerence? <numeric_value> page 546
:PULse[1]|...|10
:DURation? [query only] page 548
:PERiod? [query only] page 550
:SEParation? [query only] page 552
:TRANsition[1]|...|10
:NEGative