Keysight Technologies P Series

TRIGger Subsystem 14
Keysight N8262A Programming Guide 583
TRIGger[1]|2:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2]
This command configures the trigger system to respond to the specified source.
This command only selects the trigger source. Use the INITiate command to
place the power meter in the wait for trigger state.
Syntax
NOTE
This command has been included for compatibility purposes. It has the same
purpose as TRIGger[:SEQuence[1]|2]:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2] which should be used in
preference.
TRIG
:SOUR
1
2
BUS
EXT
Space
HOLD
IMM
INT
1
2
?