CALCulate Subsystem 3
Keysight N8262A Programming Guide 217
CALCulate[1]|2|3|4:RELative Commands
These commands compare the measurement signal to a reference value.
Within the CALCulate block the relative value is applied to the measurement
signal after any math calculations and display offsets have been applied.
The commands described in this section:
CALCulate[1]|2|3|4:RELative[:MAGNitude]:AUTO <boolean>|ONCE
CALCulate[1]|2|3|4:RELative:STATe <boolean>
To Next Page
Loading...
