14 TRIGger Subsystem
596 Keysight N8262A Programming Guide
TRIGger[:SEQuence]:SLOPe <character_data>
This command specifies whether a trigger event is recognized on the rising or
falling edge of a signal.
Syntax
Parameters
Reset Condition
On reset the value is set to POSitive.
Query
TRIGger[:SEQuence]:SLOPe?
The query returns the current value of <character_data>.
Query Example
:SLOP
Space
?
character_data
TRIG
:SEQ
Item Description/Default Range of Values
character_data How a trigger event is recognized:
– POSitive: a trigger event is recognized on the rising edge of a
signal.
– NEGative: a trigger event is recognized on the falling edge of a
signal.
POSitive
NEGative
TRIG:SEQ:SLOP? This command queries the current value of
<character_data> for Channel A.
To Next Page
Loading...
Need help?
General
