10 SENSe Subsystem
352 Keysight N8262A Programming Guide
Query Example
Error Messages
If [SENSe[1]]|SENSe2:AVERage:COUNt:AUTO is set to ON while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error –221, “Settings Conflict”
occurs. However, automatic averaging is enabled but the
[SENSe[1]]|SENSe2:AVERage:STATe command is not automatically set ON.
AVER:COUN:AUTO? This command queries whether automatic filter
length selection is on or off for Channel A.
To Next Page
Loading...
