MEASurement Commands 2
Keysight N8262A Programming Guide 147
Example
Error Messages
– If the last measurement is not valid error –230, “Data corrupt or stale” occurs.
A measurement is valid after it has been initiated. It becomes invalid when
either a reset occurs or any measurement parameter, for example frequency, is
changed.
– If the expected_value and resolution parameters are not the same as the
current expected value and resolution setting on the specified window, error
–221, “Settings conflict” occurs.
resolution A numeric value for the resolution. If it is unspecified the
current resolution setting is used. If a value is entered it should
correspond to the current resolution setting otherwise an error
occurs.
1 to 4
[b]
1.0, 0.1, 0.01, 0.001
DEF
[a]
source list The channel which the command is implemented on. If
unspecified the current window setup is used. However, if the
window shows a ratio or difference measurement, the upper
window defaults to Channel A and the lower window to
Channel B.
(@1)
(@2)
[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command sub-systems. The parameters must
be entered in the specified order. If parameters are omitted, they default from the right. The parameter DEFault is used as a place holder.
Specifying DEF leaves the parameter value unchanged.
[b] When the measurement result is linear this parameter represents the number of significant digits. When the measurement result is
logarithmic 1 to 4 represents of 1, 0.1, 0.01 and 0.001 respectively.
FETC2:POW:AC? This command queries the lower window/
upper measurement result.
Item Description/Default Range of Values
To Next Page
Loading...
