1 Power Meter Remote Operation
56 Keysight N8262A Programming Guide
Introduction
This chapter describes the parameters which configure the power meter and help
you determine settings to optimize performance. It contains the following
sections:
– “Configuring the Remote Interface” on page 57.
– “Zeroing and Calibrating the P-Series Power Sensor” on page 59.
– “Making Measurement” on page 61.
– “Using Frequency Dependent Offset Tables” on page 77.
– “Setting the Range, Resolution and Averaging” on page 84.
– “Setting Offsets” on page 88.
– “Setting Measurement Limits” on page 90.
– “Getting the Best Speed Performance” on page 94.
– “How Measurements are Calculated” on page 99.
– “Status Reporting” on page 100.
– “Saving and Recalling Power Meter Configurations” on page 106.
– “Using Device Clear to Halt Measurements” on page 107.
– “An Introduction to the SCPI Language” on page 108.
– “SCPI Compliance Information” on page 117.
– “Summary of Commands” on page 119.
– “Making Measurements on Wireless Communication Standards” on page 120.
To Next Page
Loading...
Need help?
General
