Keysight N8262A P-Series Modular Power Meter
Programming Guide
55
1 Power Meter Remote
Operation
Introduction 56
Configuring the Remote Interface 57
Zeroing and Calibrating the P-Series Power Sensor 59
Making Measurement 61
Using Frequency Dependent Offset Tables 77
Setting the Range, Resolution and Averaging 84
Range 86
Setting Offsets 88
Setting Measurement Limits 90
Getting the Best Speed Performance 94
How Measurements are Calculated 99
Status Reporting 100
Saving and Recalling Power Meter Configurations 106
Using Device Clear to Halt Measurements 107
An Introduction to the SCPI Language 108
SCPI Compliance Information 117
Summary of Commands 119
Making Measurements on Wireless Communication Standards 120
This chapter describes the parameters that configure the power meter and helps
you determine settings to optimize performance.
To Next Page
Loading...
Need help?
General
