2 MEASurement Commands
180 Keysight N8262A Programming Guide
MEASure[1]|2|3|4[:SCALar][:POWer:AC]:RATio?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window’s measurement function to ratio mode
with relative mode off, aborts, configures then initiates both Channel A and B,
calculates the ratio measurement result and places the result on the bus. The
result is a ratio based measurement and is expressed in the units defined by
UNIT[1]|2|3|4:POWer:RATio.
Syntax
Parameters
Refer to “Optional Parameters” on page 126 for additional details on the
parameters in this command.
:POW
:AC
?
:SCAL
:RAT
Space
expected_value
DEF
resolution
,
DEF
source list
,
MEAS
1
2
3
4
Item Description/Default Range of Values
expected_value
(for the expected power
level)
The power meter ignores the numeric value entered in this
parameter. Any value entered is treated like DEF.
Sensor dependent
DEF
[a]
To Next Page
Loading...
Need help?
General
