Keysight Technologies P Series User Manual

7 MEMory Subsystem
304 Keysight N8262A Programming Guide
MEMory:TABLe Commands
These commands are used to define a sensor calibration table (8480 Series
sensors only) or a frequency dependent offset table, and to write to and read data
from it.
The following commands are described in this section:
MEMory:TABLe:FREQuency <numeric_value>{,<numeric_value>}
MEMory:TABLe:FREQuency:POINts?
MEMory:TABLe:GAIN[:MAGNitude]
<numeric_value>{,<numeric_value>}
MEMory:TABLe:GAIN[:MAGNitude]:POINts?
MEMory:TABLe:MOVE <character_data>,<character_data>
MEMory:TABLe:SELect <character_data>

Keysight Technologies P Series Specifications

General

Brand	Keysight Technologies
Model	P Series
Category	Measuring Instruments
Language	English