Keysight Technologies P Series

10 SENSe Subsystem
412 Keysight N8262A Programming Guide
SENSe[1]|2:TRACe:LIMit:UPPer <numeric_value>
This command sets the upper scale limit of the trace for the specified channel.
The units used are dependent on the current setting of SENS:TRAC:UNIT as shown
in Table 10-2.
Syntax
Table 10-2 Measurement units
Units:
SENS:TRAC:UNIT
Units:
SENS:TRAC:LIM:UPP
dBm dBm
WW
NOTE
The trace lower scale limit is maintained at a lower power than the upper scale
limit which is adjusted to be slightly greater than the lower scale limit if
necessary. Refer to“SENSe[1]|2:TRACe:LIMit:LOWer <numeric_value>” on
page 410 for further information on setting the trace lower scale limit.
:SENS
1
2
:TRAC
Space
?
numeric_value
DEF
MIN
MAX
MIN
MAX
Space
:UPP
:LIM