10 SENSe Subsystem
372 Keysight N8262A Programming Guide
Query
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:STATe?
The query returns a 1 or 0 into the output buffer indicating whether a table is
enabled or disabled.
– 1 is returned when the table is enabled
– 0 is returned when the table is disabled
Query Example
Error Messages
If you attempt to set this command to ON and no table has been selected using
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:[SELect] then error –221,
“Settings conflict” occurs and
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:STATe remains OFF.
SENS2:CORR:CSET1:STAT? This command queries whether there is
currently an active sensor calibration table
for Channel B.
To Next Page
Loading...
